Boeing design manual fasteners

• Fasteners with a shank may be up or down 1 grip • All thread fasteners up or down two grips • 1 or 2 washers may be added of same basic part of existing washer may be used • “L” series washers are acceptable • Not allowed in blind areas unless the hole is measured • Blind location must be documented • May combine 1 2. Aero 07 - Design for Corrosion. Boeing designs airplanes to resist corrosion through selection of the proper materials and finishes and the use of drainage, sealants, and corrosion inhibitors. These designs are based on knowledge of what causes corrosion and the types of corrosion that occur in airplane structure. Boeing Process Specification Index SCOPE This document covers the issue status and process specification departures (PSD) applicable to Boeing specifications used on make-to-print parts for Moog Wolverhampton. The listing is designed as a look up tool for Supply Chain to determine the latest specification.

Common design practice is to use a nominal edge distance of 2 D from the fastener hole centerline, where D is the fastener diameter. The minimum edge distance should not be less than D. The nominal distance between fasteners is 4 D, but the thickness of the materials being joined can be a significant factor. BDM Boeing Design Manual. A set of Heritage Boeing documents that define approved analysis methods, processes, material properties and design values. CSW Common Structures Workstation. CSW will provide analysts with an interrelated suite of tools that support the vast majority of structural analysis tasks. • Fasteners with a shank may be up or down 1 grip • All thread fasteners up or down two grips • 1 or 2 washers may be added of same basic part of existing washer may be used • “L” series washers are acceptable • Not allowed in blind areas unless the hole is measured • Blind location must be documented • May combine 1 2.

Boeing's X airplane is completed at the Boeing Defense, Space followed by a final station for cleanup and manual fastener. Some reports, in fact, suggest that a typical Boeing contains roughly Blind rivets are a common type of fastener used in airplanes. Boeing designs airplanes to resist corrosion through selection of the proper Nonaluminum fasteners on the exterior of the airplane and those that.